When a toilet problem is an emergency
A running toilet is a nuisance. An overflowing one is an emergency, because water and waste spread across a bathroom floor and into the ceiling below. We book same-day visits for urgent toilet calls when we have a technician free.
- A toilet that overflows when flushed or will not stop filling.
- Water leaking at the base, the tank or the supply line.
- A toilet backing up with other fixtures also slow or gurgling.
- The only toilet in the house is out of service.
What to do before we arrive
- Close the shutoff valve. Turn the valve on the wall or floor behind the toilet clockwise until it stops. This ends the fill.
- Lift the tank lid if it keeps running. Raise the float or lift the flapper chain to stop the flow while you wait.
- Do not keep flushing. More flushes add more water to a blocked drain.
- Mop up and ventilate. Clean standing water quickly and keep children and pets away.
Common toilet problems and fixes
| Problem | Usual cause | Fix |
|---|---|---|
| Runs constantly. | Worn flapper, fill valve or chain. | Replace the part, which is usually quick. |
| Weak flush. | Clogged rim jets, low water level or partial clog. | Clean, adjust or clear. |
| Clogged. | Too much paper, a foreign object or a downstream blockage. | Closet auger, or a line clear if other drains are affected. |
| Leaks at the base. | Failed wax ring or loose bolts. | Reset the toilet with a new seal. |
| Rocks on the floor. | Loose flange or uneven floor. | Reset with shims and a new seal. |
| Sweats or drips from the tank. | Condensation or a failed tank bolt gasket. | Replace gaskets, consider an insulated tank. |
If more than one fixture is slow, the problem is in the drain line rather than the toilet. Our drain cleaning page explains how we tell the difference.
Toilet installation and replacement
A toilet that has cracked, rocks no matter how many times it is reset, or wastes water on every flush is a candidate for replacement. We remove the old one, inspect the flange and the floor, set the new toilet on a new wax ring or seal and test for leaks.
Choose a model that fits the rough-in distance, the distance from the wall to the center of the drain. Most are 12 inches, but older homes vary. We measure before you buy, so the toilet you pick will fit. We also check the shutoff valve and the supply line, which are cheap to replace while the toilet is off.
Plainfield note: older bathrooms
Many Plainfield houses date from the late 1800s and early 1900s, and their bathrooms have been remodeled in pieces. A new toilet may sit on a floor flange that was set for an older fixture, or on a subfloor that has softened from years of small leaks. We check the floor and the flange before closing it up, because a rotted subfloor makes any toilet rock.
If a slow leak has been reaching the ceiling below, our leak detection page explains how we find the source.
What affects the price of toilet repair
- Repair or replacement.A flapper or fill valve costs far less than a new toilet.
- Floor and flange condition.Rot or a damaged flange adds repair work.
- Fixture choice.Standard, comfort-height and wall-hung toilets vary widely in cost.
- Shutoff and supply line.Old valves that will not close are replaced.
- Time of day.After-hours dispatch is priced differently from a scheduled visit.
Call (908) 357-1542 for your real number.
Toilet overflowing or leaking?
Close the shutoff, then call. Tell us what it is doing and we will bring the right parts.
Where we repair toilets
We repair and install toilets across Plainfield, including the 07060, 07062 and 07063 ZIP codes, and in North Plainfield, Fanwood and Scotch Plains.
Toilet repair questions
Yes. Dispatch is open 24/7. An overflowing or leaking toilet is treated as urgent, and we book same-day visits when a technician is available. Call (908) 357-1542.
Usually a worn flapper, a flapper chain that is too tight or a fill valve that does not shut off. These are inexpensive to replace.
Frequent clogs point to a low-flow model, too much paper, flushed wipes or a partial blockage in the drain. If other fixtures are slow, the line needs cleaning.
A failed wax ring, loose bolts or a leaking supply line. Water at the base can also be condensation, so we check before we pull the toilet.
A standard replacement usually takes about an hour or two, and longer if the flange or floor needs repair.
It is a doable job, but a wrong seal, an uneven set or a cracked bowl from over-tightening causes leaks later. We handle it so it is done once.
